I HAVE SEARCH A LOT AND SOMEONE SAID TO SHORT CIRCUIT SOME PIN OF FLASH AND CONNECT IT AGAIN IT WILL BE DETECTED. SINCE THAT DAY I AM UNABLE TO CONNECT IT AGAIN TO MY PC.WHENEVER I CONNECT IT IS NOT RECOGNIZED BY MY PC.AT THAT TIME I WAS NOT AWARE THAT WHILE UPDATING FIRMWARE PLAYER SHOULD NOT DISCONNECT. ONE DAY WHEN I WAS UPDATING THE FIRMWARE BY PRESSING TE KEY COMBINATION IT WAS DETECTED BY MY PC.īUT WHILE UPDATING I HAVE DISCONNECTED FROM THE PC BECAUSE IT WAS TAKING LONG TIME. I HAVE ITS DRIVER ,PROGRAMS AND FIRMWARE ETC. I HAVE UPDATED MY FIRMWARE MANY TIMES BY CONNECTING WITH THE PC.
who details which i have found on opening it are as follow: Soem work perfectly, some don't interface with my computer, but I have NEVER had this problem before. Again, I have owned about 5 of these things. I've tried changing all the various SETUP settings and NOTHING helps. You can play those files on the computer from the device so the data is uncorrupted, IT'S IN THERE!!!! The device just won't play anything. You can plug it in, go to DISK G (the drive I assigned it) and all the files ARE THERE!!!! It's LIKE a large flash drive that stores all the files you tranfer to it, it just can't play those files itself. Here's the wierd thing, and I've owned several of these things: usually the problem is the device not interfacing with your computer, that IS NOT the problem. There is a reset button in the back of the player, no help. That includes photos, videos, MP3's, and even the games that were pre-installed on the unit. I made no changes to it but a week later it refused to play ANYTHING.
Now install and launch FSM Pro flashing utility and follow these instructions to install the new firmware.
Once identified you need to connect your device to computer via USB in camera mode (Press A + OK button and plugin USB cord on player), for Windows to identify this mode you will need camera drivers you need to point Windows Found New Hardware Wizard to Driver folder downloaded with the FRM Pro utility above, this will install the first camera driver, for correct identification by flashing utility you need to install a second camera driver - open Windows Hardware Manager and install unidentified camera device drivers by pointing the driver wizard to Driver folder used earlier.In my case the chipset was Sunplus AJ262-V7 and the utility needed to flash it was FRM Pro.You will now need to download the correct firmware and flashing utility for your device, visit sites below and search for your control chip and cpu to download the firmware and flashing utility, you can also post on user-forums to get help identifying the firmware :.